elektraLite 1018 QUAD 18-12w QUAD LED - Manual (Page 10)

5).RGBW
The RGBW setting allows the ability to calibrate the white achieved when mixing RGB.
When RGBW is set to OFF, the output when Red, Green, and Blue is at maximum is 255 for all three
colors. By definition this combination produces a white with a blue tinge which affects all other colors if
cameras and other video equipment are "keyed" to this.
When RGBW is set to ON, the output can be white balanced to whatever looks good on camera, for
example. It also serves to balance the white into a "warm" white which makes people look a lot better
when they are in the light!
See Cal 2, for how to calibrate the white when the RGBW is turned ON.
To turn RGBW either OFF or ON, go through the Root Menu until RGBW. Press Enter and then use
the
↑ or ↓ buttons to get to either OFF or ON. Once chosen, press Enter to save the setting and then
Menu to exit out back to the Root Menu.
6). DV
The DV setting allows the ability of the leds to not flicker when using video camera.
The choices are NTSC or PAL. NTSC is the USA system.
To set the DV setting, go through the Root Menu until DV. Press Enter and then use the
↑ or↓ buttons
to get to either NTSC or PAL. Once chosen, press Enter to save the setting and the Menu to exit back
to the Root Menu.
15. CAL 1
There are 11 preprogrammed white settings which can be accessed via DMX channel 6.
The 11 settings are labeled WT 01 through to WT11.
Each of the settings can be adjusted/edited.
To do this, go through the Root Menu until CAL 1. Press Enter and then use the
↑ or ↓ buttons to get to
the WT to be edited; for example WT01. Press Enter. The display will read R223 which is the default
setting for the Red LED value (dmx 223) for WT01. To change this value, use the
↑ or ↓ button. Once
the correct value is chosen press Enter to save and automatically the Green value will be present
(which is G255). Again use the
↑ or ↓ to change the value and press Enter to save and move
automatically to the Blue value (B029). Again use the
↑ or ↓ to change the value and press Enter to
save and move automatically back to the Red value. Use the Menu button to exit out to the Root Menu.
As there are 11 different white settings, there values can all be changed. See channel 6 on the DMX
chart for the complete listing and what each of the white's color temperature is set to.