elektraLite 1018 QUAD 18-12w QUAD LED - Manual (Page 3)

3. General Guidelines.
ElektraLite LED Pro Line 1018 is a lighting fixture for professional use on stages, in clubs, theatres,
etc.
ElektraLite LED Pro Line 1018 should only be operated at between 120 to 240 volts and only indoors.
ElektraLite LED Pro Line 1018 should not be operated 24/7 (24 hours a day; 7 days a week).
ElektraLite LED Pro Line 1018 needs operation breaks to ensure that it will work for a long time
without problems. Please do not shake ElektraLite LED Pro Line 1018 and avoid using brute force
when installing or operating it.
When choosing the location to install ElektraLite LED Pro Line 1018 , please make sure that it is not
exposed to extreme heat, moisture or dust. The minimum distance between ElektraLite LED Pro Line
1018 and the illuminated surface must be more than 3 feet.
Always mount ElektraLite LED Pro Line 1018 with an appropriate safety cable.
Operate ElektraLite LED Pro Line 1018 only when you are familiar with the features on the fixture. Do
not permit operation by persons not qualified for operating it.
All modifications to ElektraLite LED Pro Line 1018 will invalidate the warranty. There are
absolutely no exceptions.
If ElektraLite LED Pro Line 1018 is operated in any way different to the one described in this manual,
ElektraLite LED Pro Line 1018 maybe damaged and the guarantee will be void.
4. Installation
Please ensure that the ElektraLite LED Pro Line 1018 is hung using the appropriate "C" clamp or half
cheeseboro. A safety chain or cable should also be used as a secondary point of holding the fixture in
case the clamp comes loose. Never hang the fixture without a safety chain or cable. Make sure the Gel
frame (Gel holder) is clipped into position correctly and cannot come loose.
If you are not qualified or have any doubts about hanging the ElektraLite LED Pro Line 1018 then do
NOT hang it.
Do not clamp the cable to the U bracket or clamp. That is not a secondary safety point.
A secondary safety point is any point that will adequately hold the ElektraLite LED Pro Line 1018 if
the "C" clamp or half cheesboro fails. Then the safety cable would be the backup and stop the fixture
from falling to the ground. So do NOT fix the safety to the same place that the "C"clamp is attached.