elektraLite MM 150 - Manual (Page 13)

-
１２ -
1. Press [MODE/ESC] to enter the main menu (display flashing).
2. Press [UP] or [DOWN] button to select “EDIT”.
- Define the number of steps in Run
With this function you can define the number of steps in the Program Run.
1. Select
“STEP” by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows “S-XX”, “X” stands for the total amount of steps you want to save, so
you can call up to 48 scenes in “RUN”. For example if the “XX” is 05, it means that “RUN” will run the first 5
scenes you saved in “EDIT”.
3. Press
[ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
- Editing the channels of the individual scenes
With this function you can edit the program to be called up in Run.
a) Editing via the fixure’s display panel
1. Select
“SC01” by pressing [UP] or [DOWN] button.
2. Press [ENTER] , the display shows “SCXX”, “X” stands for the scene number to be edited.
3. Change the scene number by pressing [UP] or [DOWN] button.
4. Press
[ENTER] , the display shows “C-X”, “X” stands for the channel number Such as “C-01”, it means
you are editing channel 1 of the selected scene.
5. Select the channel no. you would like to edit by pressing [UP] or [DOWN] button.
6. Press
[ENTER] to enter editing for the selected channel. The fixture reacts to your settings. The display
shows the DMX value of the edited channel. Such as “ 04XX”, it stands for in the channel 04 of the editing
scene, the DMX value is XX , XX is a hexadecimal number value “01-FF”.Adjust the desired DMX value by
pressing [UP] or [DOWN] button.
7. Press
[ENTER] in order to edit other channels of this scene.
8. Repeat steps 5-9 until you finish setting all the DMX values for all channels of this scene.
9. Once all the channels completed, the display will flash “TIME”
10. Press [ENTER] to edit the time needed, the display shows “t--X”,“X” stands for the time needed to run the
current scene, value “1-9”. For example, “t--2” means you need 2 seconds to run the current scene.
11. Adjust the desired time by pressing [UP] or [DOWN] button.
12. Press [ENTER] to save the settings for the scene you are editing, the display will change to the next scene
automatically.
13. Repeat step 3-14 to edit and other scenes, you can edit and save a maximum of 48 scenes.
14. Press [MODE/ESC] to exit. The number of steps can be defined under “STEP” and the scenes can be
called up under “RUN”
b) Editing via an external controller like an Elektralite CP10xt
Call up the first scene in your controller now.
1. Select “SC01” by pressing [UP] or [DOWN] button.
2. Press [ENTER] , the display shows “SC01”.
3. Press [ENTER] , the display shows “C-01”.
4. Select "CNIN" by pressing [UP] or [DOWN] button.
5. Press [ENTER] , the display shows "OFF".
6. Press [UP] or [DOWN] button .the display shows "ON".
7. Press [ENTER] , the display shows "SC02". You successfully downloaded the first scene.
8. Adjust the Step-time as described above.
9. Call up the second scene in your controller now.
10. Repeat steps 5-9 until all desired scenes are downloaded.
11. Press [MODE/ESC] to exit. The number of steps can be defined under “STEP” and the scenes can be
called up under “RUN”