elektraLite MM 150 - Manual (Page 17)

-
１６ -
CLEANING AND MAINTENANCE
The following points have to be considered during the inspection:
1) All screws for installing the devices or parts of the device have to be tightly connected and must
not be corroded.
2) There must not be any deformation on the fixture or the suspension point. In other words check
the truss, ceiling, threaded rods or whatever is holding up the fixture. That also includes the safety
cable or chain!
3) Mechanical moving parts must not show any traces of wearing and must not rotate out of balance.
4) The electric power supply cables must not show any damage, material fatigue or sediment.
We recommend frequent cleaning of the device. Please use a moist, lint- free cloth. Never use alcohol or
solvents. PLEASE clean around the fans and any air vents. If you do not do this regularly you will
dramatically decrease the life of the lamp and the fixture itself. If it cannot “breath” it is going to die!!!
Use a vacuum cleaner NOT an air hose/can. Unless you prefer to blow the dust all over the colors and
gobos!!!
There are no serviceable parts inside the device, except for the lamp. Please refer to the
instructions under “Installation instructions” for lamp change.
Should you need any spare parts, please order genuine parts from your local dealer.
TECHNICAL SPECIFICATIONS
Power supply :
□98VAC,50Hz;□120VAC,50Hz;□208VAC,50Hz;□220VAC,50Hz;□230VAC,50Hz;□240VAC,50Hz;
Power consumption : max.
□
230W
Lamp :
□ HSD150 G12 socket, Metal Halide;
Motors :
6 micro motors
Packing dimensions : 67x37x34cm (26½”x14½”x13½”)
Net weight :
□10.5KGS (23.1 pounds)
Gross weight:
□12.5KGS (27½ pounds)
Remark :
We obviously try not to have any errors in the manual but errors and omissions for
information in this manual has to be excepted. Further all information is subject to change without
prior notice.