AT&T CL82609 - Manual (Page 30)

Multiple handset use
25
Intercom
Use the intercom feature for conversations between handsets. This feature is
not available for model CL82109 unless you have purchased additional
handsets (CL80109).
You can buy additional expansion handsets (model AT&T CL80109) for this
telephone base. You can register up to 12 handsets to the telephone base.
The first nine handsets that you register are named Handsets 1-9. Use the
handset number to initiate intercom and transfer calls.
Although the names for handsets 10-12 appears in their displays as 10-12,
when you intercom or transfer to one of them, you must use *0 for Handset
10, *1 for handset 11, and *2 for Handset 12.
1. Press INT on your handset when not in use.
• If you have a two-handset system, your handset
screen shows CALLING OTHER HANDSET.
• If you have more than two handsets, your screen
shows INTERCOM TO: Use the dialing keys to
enter a handset number. Your handset screen
shows CALLING HANDSET X.
The other handset rings and its screen shows either OTHER
HANDSET IS CALLING or HANDSET X IS CALLING.
2. To answer the intercom call, press PHONE/FLASH,
INT, SPEAKER or any dial pad keys (0-9, #, *) on the
other handset. Both handsets now show INTERCOM.
3. To end an intercom call, press INT, OFF/
CLEAR
, or
place the handset back in the telephone base or charger.
NOTES:
1. Before the intercom call is answered, you can cancel the intercom call by pressing
OFF/CLEAR or INT on the calling handset.
2. If the called handset is not answered within 100 seconds, or if it is in the directory
or call log mode, or is out of range, or is on a call, the calling handset shows the
message UNABLE TO CALL TRY AGAIN.
3. Pressing OFF/
CLEAR
or MUTE/
DELETE
temporarily silences the intercom ringer.
4. You can use a maximum of four handsets at a time. When you use two handsets on
an intercom call, others can use two other system handsets for an outside call.
DBMMJOH
PUIFS!IBOETFU
PUIFS!IBOETFU
JT!DBMMJOH
JOUFSDPN