Avocent DSR 1024 - Manual (Page 26)

14 DSR1024 Switch Installer/User Guide
4. Set the Select a pointer speed slider to the default of midpoint (the fifth tick mark from
the left).
5. Uncheck the Enhance pointer precision checkbox.
6. Make sure the Snap To and the Visibility checkboxes are unchecked.
7. Click OK to close the Mouse Properties dialog box and to save your settings.
8. Resynchronize the mouse in the software remote session window for the Avocent management
software you are using:
• If you are using DSView software version 2.x or earlier, click Mouse Align.
• If you are using DSView software version 3.0 or later, click Align Local Cursor.
• If you are using the AVWorks software, click Screen Refresh.
The mouse resynchronizes and should work properly.
To adjust the mouse speed and cursor settings for IntelliPoint drivers:
1. From the Desktop, select Start - Control Panel to open the Control Panel window.
2. From the Control Panel, double-click the Mouse icon to open the Mouse Properties dialog box.
3. Click the Pointer Options tab.
4. Set the Select a pointer speed slider to the default of midpoint (the fifth tick mark from
the left).
5. Uncheck the Enhance pointer precision checkbox.
6. Make sure the Snap To and the Visibility checkboxes are unchecked.
7. Click the Wheel tab.
8. Uncheck the Enable accelerated scrolling ... checkbox.
9. Click OK to close the Mouse Properties dialog box and to save your settings.
10. Resynchronize the mouse in the software remote session window for the Avocent management
software you are using:
• If you are using DSView software version 2.x or earlier, click Mouse Align.
• If you are using DSView software version 3.0 or later, click Align Local Cursor.
• If you are using the AVWorks software, click Screen Refresh.
The mouse resynchronizes and should work properly.