Avocent DSR 1024 - Manual (Page 63)

Chapter 5: Terminal Operations 51
keyboard. Sun servers will interpret pressing the Y key on a German keyboard as pressing the Z key
when the US keyboard country code is used.
The Keyboard command enables you to send a different keyboard country code than the default US
setting. The specified country code is sent to the target device attached to the DSR1024 switch
when it is powered up or rebooted and the new code is stored in the DSRIQ module.
See Appendix F on page 64 for information on emulating certain Sun keys using a PS/2 keyboard
and special considerations for Japanese and Korean Sun USB keyboards.
NOTE: You can only view or change keyboard country code settings via the Console menu on the SETUP port.
To set the keyboard country code for Sun servers:
1. Type 5 and press Enter to select the Keyboard Layout Configuration menu option. A list of
countries will appear.
2. Select the country from the list by number, or press 0 (zero) to save your changes, if any,
and exit.
3. Reboot the Sun server. After rebooting, the Sun server will request the country code setting
stored in the DSRIQ module.
NOTE: If you wish to reboot the target device by power-cycling it, you must wait 90 seconds before rebooting. A
soft reboot may be performed without waiting 90 seconds.
Display Version Information
When you select this menu item from the Main menu, all important version information for the
switch hardware and firmware displays. You can also select to view the DSRIQ module
version information.
Rename DSRIQ
Select this menu item from the Main menu to change the name of the attached DSRIQ module.
To change the name of the DSRIQ module:
1. Type 7 and press Enter to select the Rename DSRIQ module menu option. The current DSRIQ
EID and Name display.