Sony KDE-W50A11E - Manual (Page 21)

21 GB
KDE-W50A11E
2-657-531-11(1)
Usi
ng t
he
M
enu
Viewing pictures
from connected
equipment
Switch on the connected equipment, then
perform one of the following operation.
For equipment connected to the scart
sockets using a fully-wired 21-pin scart lead
Start playback on the connected equipment.
The picture from the connected equipment appears on
the screen.
For other connected equipment
Press
/ repeatedly until the correct input
symbol (see below) appears on the screen.
Additional operations
Navigating through
menus
1
Press MENU to display the menu.
2
Press M/m to select a menu icon.
3
Press M/m/</, to select an option.
4
Press M/m/</, to change/set the
setting, then press OK.
To exit the menu, press MENU.
To return to the last display, press
<.
1/ 1, 2/ 2, 3/ 3:
Audio/video or RGB input signal through the scart
socket
/ 1, 2 or 3. appears only if an RGB
source has been connected.
4:
Component input signal through the Y, P B /C B , P R /C R
sockets / 4, and audio input signal through the
L/G/S/I, R/D/D/D sockets / 4.
5:
Digital audio/video signal is input through the HDMI IN
5 socket. Audio input signal is analogue only if the
equipment has been connected using the DVI and audio
out socket.
6/ 6:
Video input signal through the video socket 6, and
audio input signal through the audio socket L/G/S/I
(MONO), R/D/D/D sockets
6. appears only if
the equipment is connected to the S video socket 6
instead of the video socket 6, and S video input
signal is input through the S video socket 6.
To Do this
Return to the normal
TV operation Press DIGITAL or ANALOG.
Access the Input
signal index table Press OK to access the Input signal
index table. (Then, only in
analogue mode, press
,.) To
select an input source, press M/m,
then press OK.
Using the Menu
1
4
2,3,4
Continued
010COV.book Page 21 Tuesday, September 6, 2005 11:47 AM