Sony KDE-W50A11E - Manual (Page 33)

33 GB
KDE-W50A11E
2-657-531-11(1)
Usi
ng t
he
M
enu
Assigns a name to any equipment connected to the side and rear sockets. The name will be
displayed briefly on the screen when the equipment is selected. You can skip an input source
that is not connected to any equipment.
1
Press OK to select “AV Preset”.
2
Press M/m to select the desired input source, then press OK.
3
Press M/m to select the desired option below, then press OK.
Before selecting “Label”/“AFT”/“Audio Filter”/“Skip”/“Decoder”/“ATT”, press PROG +/-
to select the programme number with the channel. You cannot select a programme number
that is set to skip (page 35).
1
Press OK to select “Manual Programme Preset”.
2
Press M/m to select one of the following options, then press OK.
AV Preset
Option Description
Equipment
labels Uses one of the preset labels to assign a name to connected
equipment.
Edit Creates your own label. Follow steps 3 to 5 of “Programme Labels”
(page 32).
Skip Skips an input source that is not connected to any equipment when
you press
M/m to select the input source.
Manual Programme Preset (Analogue mode only)
Continued
010COV.book Page 33 Tuesday, September 6, 2005 11:47 AM