Antec DF-85 - Manual (Page 15)

15
2. Push the power supply to the back of the case and align the mounting holes.
3. Attach the power supply to the case with the screws provided.
2.4 I NSTALLING A CPX F ORM F ACTOR P OWER S UPPLY
The DF-85 can accommodate an Antec CPX form factor CP-series high performance power supply. An
adapter plate for standard power supplies is pre-installed with standard Phillips-head screws and must be
removed for a CPX form factor power supply to be installed.
1. Open the left side of the case. Turn the case around so that the back of the case is facing you.
Remove the screws indicated below.
Adapter plate screws. Your CPX power supply will use different screw locations than an ATX power supply.
Make note of them and carefully secure your CPX power supply to your case.
Note: Power supplies with fans on the bottom of the power supply will need to be mounted so
that the fan is facing the top of the case. The DF-85 provides mounting holes for power
supplies with standard mounting layouts to be installed right side up or upside down.
Note: Carefully remove the adapter plate and set it aside – you will need it again if you ever decide
to switch to a standard-form-factor power supply.