Antec DF-85 User Manual
Page 19
19
Installing a 3.5” internal device
3. Fasten the device in place with the provided screws on both side of the drive cage.
Make sure to install screws on the left side…
…as well as the right side.
4. Mount any other 3.5” HDD devices accordingly.
5. Connect the appropriate power and data cables to the device(s), using cable routing as desired.
6. Close the Fleet-ReleaseTM Access Door.
2.7
U
SING
F
LEET
-S
WAP
™
The DF-85 includes two sets of Fleet-Swap
TM
3.5” drive bays. Each set contain two connectors, for a total of
four hot-swappable SATA drive bays, pre-installed on the top and bottom of the internal 3.5” drive cage.
A.
P
REPARING YOUR
F
LEET
-S
WAP
™
SATA
BAYS FOR USE
1. Remove the left side panel of the case. Open the Fleet-Release
TM
Access Door by pressing the left
side to release it, then swing it open. Locate the Fleet-Swap bays inside the drive cage.