页 10, 9operating your kegerator – NewAir Kegerator AK-200 User Manual

Page 10

Advertising
background image

Illustration A
Black Rubber Washer Installed in Wing Nut

Illustration B
Then Attach to CO2 Bottle Connector

fig.1

fig.2

fig.3

fig.4

fig.5

Connect to the
Beer Line Tube

Black pull handle

Keg Coupler

Connect to
CO2 Gas
Line Tube

OCKWISECL

RN

TU

Beer Keg Neck

Lift Upright

Beer Keg

Keg Support

Operating Your Kegerator
Dispensing Beer
Follow the steps below to dispense beer.

Make sure that the kegerator is plugged in properly to a 120V, 60Hz,
15Amps grounded AC power outlet.

Place the drip tray under the beer faucet to avoid messes from excess beer.

Open the beer faucet by pulling the tap towards you to dispense the beer.
Note: If for any reason the beer does not come out of the tap, please refer to the
“Tapping the Beer Keg - Installing Keg Tap” section.

Increase the pressure if the beer runs too slowly.

Hold the glass steady at a 45° angle. When it is 2/3 full, straighten the glass.
Proper foam should be a tight creamy head and the collar on an average glass
should be ¾” to 1” high, ideally.

1.

2.

3.

4.

5.

9

OPERATING YOUR KEGERATOR

Advertising