Sony PCG-GRT100K User Manual
Page 111
6.
Type a name in the Profile Name box.
7.
In the Transmission Rate box, make sure Fully Auto is selected. By selecting Fully Auto, your computer
automatically searches for the strongest (radio) signal.
8.
In the ESSID box, type the name of the access point or click Scan to select an access point.
9.
Select a Power Save option.
10. In the Network Type box, select Infrastructure to connect to or set up a network to access point (host)
connection or click Ad Hoc to connect to or set up a computer-to-computer connection.
11. If the network was not set up with an encryption key, click Apply.
12. If the network was set up with an encryption key:
1.
In the WEP Key box, select 40bit/64 bit for IEEE 802.11b access points.
2.
In the Key format box, select either ASCII mode or HEX mode, depending on the encryption key.
3.
In the Default Key box, select the correct encryption key.
4.
Type the key name in the appropriate key box.
5.
Click Apply.
To disconnect from a wireless network
Move the Wireless LAN switch to OFF. The Wireless LAN indicator turns off.
Page 111