Sony VPCB11HGX - Manual (Page 2)

VPCB1 Series Hard Disk Drive
Replacement Instructions
P/N 989201346 RevB 2/3
(Use Pre-molded indentation to
initiate cover removal)
Step 4. Pull the Hard Drive Door
towards you, using the indentation at
the top of the door.
Step 5. Using the enclosed magnetic
screwdriver, remove the one (1) screw
securing the Hard Drive Assembly. Put
aside the Hard Drive Screw to re-
secure the Hard Drive later in the
procedure.
Step 6. Disconnect the Hard Drive by
pulling the black plastic tab to the left.
Step 7. Carefully lift the Hard Drive
from the unit to remove.
Step 8. Identify the four (4) side screws
that secure the bracket to the Hard
Drive.
Step 9. Holding the edge of the Hard
Drive, remove each screw. Put aside
the Bracket Screws to secure the
Bracket to the Hard Dive later in the
procedure.
Step 12. Place the Hard Drive bracket
over the new Hard Drive. Step 10. Set the old Hard Drive aside.
Step 11. Prepare the new Hard Drive
for assembly.
Old Hard Drive New Hard Drive
Hard Drive Disassembly (Steps 8-10)
Hard Drive Assembly (Steps 11-13)
Lift To Remove