Sony VPCB11HGX User Manual
Page 3
VPCB1 Series Hard Disk Drive
Replacement Instructions
P/N 989201346
RevB
3/3
HDD Reinstallation (Steps 14-17)
Step 14. Insert the two (2) left tabs of
the new Hard Drive assembly into the
slots. Hold the Hard Drive on the sides
to avoid damage.
NOTE! Proper mounting of
the Hard Drive bracket can be
verified with the Hard Drive
connectors appearing below the
plastic pull tab.
Step 13. Re-install the four (4) Hard
Drive Bracket screws to secure the
Hard Drive bracket to the New Hard
Drive.
(Bracket should be aligned with 2 slots)
Step 15. Install the Hard Drive by
sliding the assembly to the right. Make
sure the screw holes are aligned
correctly.
Step 16. Re-install the one (1) Hard
Drive screw holding the Hard Drive
assembly in place.
Step 17. Re-attach the hard drive cover
and tighten the screw.
Step 19. Re-install the battery pack and
reconnect the AC Adaptor.
Power on your computer and continue
with the recovery process by following
the instructions described on the back
of the recovery disk’s case.
Return the old Hard Drive to
Sony using the included
shipping instructions.