Sony HCD-LX90AV - Manual (Page 14)

14
To
Stop playback
Pause
Select a track
Find a point
in a track
Select a CD
Play only the
CD you have
selected
Play all CDs
Remove or
change the
CDs
Adjust the
volume
* AMS: Automatic Music Sensor
Tips
• Pressing HX while the system power is off
automatically turns on the system and starts CD
playback if there is a CD on the tray (One Touch
Play).
One Touch Play is not available in Power Saving
mode.
• You can switch from another source and begin
playing a CD just by pressing HX, one of the
DISC 1 - DISC 5 buttons, or CD H on the remote
(Automatic Source Selection).
• If there is no CD in the player, “NO DISC”
appears in the display.
• You can change the CD which is in the loading
position during playback of the CD which is in the
playing position.
Do this
Press x.
Press HX (or X on the remote).
Press HX again to resume
playback (or CD H on the
remote).
During playback or pause, turn
the jog dial clockwise (to go
forward) or counterclockwise (to
go backward) and release it when
you reach the desired track.
Or press AMS* > (to go
forward) or AMS . (to go
backward) on the remote.
Press M or m during
playback, and release at the
desired point .
Press one of the DISC 1 - DISC 5
buttons (or DISC SKIP).
Press PLAY MODE repeatedly
until “1 DISC” appears.
Press PLAY MODE repeatedly
until “ALL DISCS” appears.
Press PUSH OPEN.
Turn VOLUME (or press
VOL +/– on the remote).
Recording a CD
— CD Synchro Recording
This function lets you easily record from a
CD to a tape. You can use TYPE I (normal) or
TYPE II (CrO
2
) tapes. The recording level is
automatically adjusted.
1
2,3 5 6 7
DSP
DOLBY NR
x h
With the label
side up.
When you play
a CD single,
place it on the
inner circle of
the tray.
With the side you want to
record on facing forward
4
? /1
(Power)
x
1
Press Z B EJECT and insert a
recordable tape into deck B.
2
Press PUSH OPEN and place a CD.
Playing a CD (continued)