Sony STR-K740P - Manual (Page 55)

Additional Information
55
GB
General
Power requirements
Area code Power requirements
U, CA, MX 120 V AC, 60 Hz
CEL, CEK 230 V AC, 50/60 Hz
SP, AR 220 – 230 V AC, 50/60 Hz
E2/E3 120/220/240 V AC, 50/60 Hz
Power consumption
Area code Power consumption
U, MX STR-K840P: 210 W
STR-K740P: 180 W
CA STR-K840P: 300 VA
STR-K740P: 260 VA
CEL, CEK, SP STR-K840P: 180 W
E2/E3, AR STR-K740P: 155 W
Power consumption (during standby mode)
0.5 W
Dimensions 430
Ч 145 Ч 298 mm
(16 7/8
Ч 5 6/8 Ч 11 6/8
inches) including
projecting parts and
controls
Mass (Approx.) 7.0 kg (15 lb 7 oz)
Speaker section
SS-MSP2 for front and surround speakers
SS-CNP2 for center speaker
Speaker system
Full range, magnetically
shielded
Speaker units 70 mm
× 100 mm cone
type
Enclosure type Bass reflex
Rated Impedance 8 ohms
Power handling capacity (Maximum input
power)
100 W
Sensitivity level 85 dB (1 W, 1 m)
Frequcency range 160 Hz – 20,000 Hz
Dimensions (w/h/d)
SS-MSP2
Approx. 81
Ч 141 Ч 121 mm
(3 1/4
Ч 5 5/8 Ч 4 7/8
inches)
SS-CNP2 Approx. 230
Ч 81 Ч 121 mm
(9 1/8
Ч 3 1/4 Ч 4 7/8
inches)
Mass
SS-MSP2
0.8 kg (1 lb 13 oz)
SS-CNP2 1.0 kg (2 lb 4 oz)
SA-WMSP4 for HT-DDW840
SA-WMSP2 for HT-DDW740
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6 ohm loads, from 28 – 200 Hz; rated 100
watts (SA-WMSP4) / 50 watts (SA-WMSP2),
minimum RMS power, with no more than 0.8%
total harmonic distortion from 250 milliwatts to
rated output (Models of area code U only).
Speaker system Active subwoofer,
magnetically shielded
Speaker unit Woofer: 20 cm cone type
Enclosure type Acoustically loaded bass
reflex
Continuous RMS power output
(6 ohms, 20 – 250 Hz)
SA-WMSP4
100 W
SA-WMSP2 50 W
Reproduction frequency range
28Hz – 200 Hz
High frequency cut-off frequency
150 Hz
Input LINE IN (input pin jacks)
continued