Sony VGX-XL2 - Manual (Page 26)

VGX-XL2A Digital Living System 23
Additional Notes:
• If your TV has a HDMI™ connector and a DVI-D connector, Sony
recommends using the HDMI™ connector.
• The HDMI cable carries both video and audio signals.
• You cannot use HDMI™ and Component Video connections at the same
time.
• If device drivers other than the ones provided by Sony are used, the image
may not be displayed and the audio may not be heard. Always use the
device driver provided by Sony for any updates.
• You can connect the HDMI™ out to an A/V receiver/amp and audio will be
heard through the AV amp and then another HDMI™ cable can be con-
nected from the AV amp to the TV for the display. (Some protected video
content may not display with this type of connection. A direct connection is
advised.)
VHF/UHF Connector (for Receiving Digital TV Transmission
If you have an antenna for receiving the over-the-air signals transmitted by a
digital TV broadcasting system, you can connect it to receive these signals for
digital televisions, for example high definition TVs. Refer to the “Connecting to
an Antenna (air) for Digital Television System (ATSC Signal Standard)” in the
next section for more information.
Additional TV Connections
Connecting to standard cable access (CATV)
Option 1
1 Connect one end of the TV coaxial cable (optional) to your cable service
access.
Note : Your VAIO® XL2A computer is supplied with certain video cables.
Depending on your in home cable access, you may require extra cables,
adapters or connection equipment not supplied with your computer.
Chp2.fm Page 23 Thursday, December 22, 2005 1:03 PM