Alliance Laundry Systems Dryer Tumblers - Manual (Page 27)

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Installation/Operation Supplement
25 70392201 (EN)
Electronic OPL Micro Control
H, L, P, S, U and Y Models with
OM Control Suffix
1. To use an Automatic Cycle, press an ON/
SELECT pad. Select HIGH, MEDIUM,
MED LOW, LOW or NO HEAT for items that
should not be dried with heat. A light to the left
of the selected pad lights up.
To use a Time Dry or Custom Cycle, refer to the
Programming Manual.
Figure 8
NOTE: Do not press directly on lights or the center
of pad. For proper selection, press on pad slightly
to the right of center. Refer to Figure 9.
Figure 9
2. Press START pad to start tumbler.
Figure 10
NOTE: All pads can be pressed in any sequence
without damaging control or tumbler. To stop the
tumbler at any time, open the door or press STOP/
RESET.
Figure 11
NOTE: The window display will flash. Press STOP/
RESET twice (within 3 seconds) to end the cycle
and reset the control to idle status. To restart the
tumbler, CLOSE door and press START pad.
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the PUSH TO
START button must be pressed in.
3. When the cycle is complete, open door and
remove the laundry.
G and K Models with OM Control Suffix
1. To use an Automatic Cycle, press a
TEMPERATURE pad. Select HIGH, MED,
LOW, DELICATE or NO HEAT for items that
should not be dried with heat. A light to the left
of the selected pad lights up.
To use a Time Dry or Custom Cycle, refer to the
Programming Manual.
Figure 12
TMB1483N
TMB806N
TMB1485N
HIGH
MEDIUM
MED LOW
LOW
NO HEAT
ON / SELECT
START
TMB1484N
TMB2201N
STOP/RESET