Alliance Laundry Systems Dryer Tumblers - Manual (Page 28)

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Installation/Operation Supplement
70392201 (EN) 26
2. Press START pad to start tumbler.
Figure 13
NOTE: All pads can be pressed in any sequence
without damaging control or tumbler. To stop the
tumbler at any time, open the door or press STOP.
Figure 14
NOTE: The window display will flash. Press STOP
twice (within 3 seconds) to end the cycle and reset
the control to idle status. To restart the tumbler,
CLOSE door and press START pad.
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the PUSH TO
START button must be pressed in.
3. When the cycle is complete, open door and
remove the laundry.
Single Drop Control
SD and SX Control Suffixes
1. Select HIGH, MED, LOW or NO HEAT by
turning the temperature knob.
Figure 15
2. Insert the coin(s) in the coin slot.
Figure 16
3. Press START button to start tumbler
Figure 17
IMPORTANT: To stop the tumbler at any time
during the cycle, OPEN DOOR. To restart the
tumbler, CLOSE door and press START button.
4. When the cycle is complete, open door and
remove the laundry.
TMB2202N
TMB2203N
TMB2147N
TMB1492N
TMB2150N
25 C