Sony VPL-HW30ES - Manual (Page 28)

28
The optional 3D Sync Transmitter* is required to view projected 3D video images.
For details on the installation of the 3D Sync Transmitter*, refer to the operating
instructions supplied with the 3D Sync Transmitter.
CAUTION
Be sure to use straight-type LAN cable of up to 15 m labeled TYPE CM, and do not use
an extension cord.
• Turn off the projector before connecting the 3D Sync Transmitter, otherwise the 3D Sync
Transmitter is not recognized.
• The 3D SYNC connector is dedicated for the optional 3D Sync Transmitter. Do not connect
computers or other network devices, to avoid malfunction.
• When you connect to a TMR-PJ1, be sure to use a straight-type LAN cable (not supplied) labeled
Cat-7 (Category 7). If you use other than the specified cable, the 3D Sync Transmitter may
occasionally not work.
• Be sure to use a cable of up to 15 m, and do not use an extension cord. Also, keep the LAN cable
away from any AC power cords as much as possible.
• Up to one 3D Sync Transmitter can be connected to the projector. Never connect multiple 3D Sync
Transmitter units, as this may cause a malfunction.
* 3D Sync Transmitter is supplied with VPL-HW30AES.
Connecting to a 3D Sync Transmitter
Notes
Right side of the projector
3D Sync Transmitter
(not supplied)*
Connecting cable (Optional for TMR-PJ1)
: 3D sync signal flow