Sony BDV-N7200W - Manual (Page 46)

46 US
BDV-N9200W/BDV-N7200W/BDV-N5200W
4-485-799-12(1)
D:\NORM'S JOB\SONY HA\SO130077\BDV-N9200_7200_5200_E3200
(PMRF 01)\4485799121_US (U2)\080OTH.fm masterpage: Left
Calibrating the
Appropriate Speaker
Settings Automatically
[Auto Calibration]
(BDV-N9200W/BDV-N7200W
only)
D.C.A.C. DX (Digital Cinema Auto
Calibration DX) brings you the ideal
sound experience by automatically
adjusting the setting of the speakers’
distance, location, and acoustic.
• The system outputs a loud test sound
when [Auto Calibration] starts. You
cannot turn the volume down. Give
consideration to children and neighbors.
• Before [Auto Calibration], make sure that
– all the speakers are connected to the
main unit and surround amplifier.
– the surround amplifier is turned on and
you have installed the surround
amplifier in an appropriate location to
ensure wireless connection with it.
1
Press HOME.
The home menu appears on the TV
screen.
2
Press B/b to select [Setup].
3
Press V/v to select [Audio
Settings], then press
.
4
Press V/v to select [Auto
Calibration], then press
.
The [Select speaker layout.] display
appears.
5
Press V/v to select setting
according to your speakers
placement, then press
.
• [Standard]: The surround
speakers are installed in the rear
position.
• [All Front]: All speakers are
installed in the front position.
The confirmation display for [Auto
Calibration] appears.
6
Connect the calibration mic to the
A.CAL MIC jack on the rear panel.
Set up the calibration mic at ear
level using a tripod, etc. (not
supplied). The calibration mic
should aim the TV screen. The front
of each speaker should face the
calibration mic, and there should be
no obstruction between the
speakers and the calibration mic.
7
Press V/v to select [OK].
To cancel, select [Cancel].
8
Press .
[Auto Calibration] starts.
The system adjusts the speaker
settings automatically.
Be quiet during the measurement.
While [Auto Calibration] is in progress,
do not operate the system.
9
Confirm the result of [Auto
Calibration].
The distance and level for each
speaker appear on the TV screen.
• If measurement fails, follow the
message then retry [Auto
Calibration].
• If no center speaker is detected, the
[Center Speaker] will be
automatically set to [Off].
Note
Note
Note