Sony BDV-N7200W - Manual (Page 65)

65 US
BDV-N9200W/BDV-N7200W/BDV-N5200W
4-485-799-12(1)
D:\NORM'S JOB\SONY HA\SO130077\BDV-N9200_7200_5200_E3200
(PMRF 01)\4485799121_US (U2)\100ADD.fm masterpage:
Right
A
d
di
tio
n
al
Inf
o
rm
at
io
n
Notes about Discs
On handling discs
• To keep the disc clean, handle the disc
by its edge. Do not touch the surface.
• Do not stick paper or tape on the disc.
• Do not expose the disc to direct
sunlight or heat sources such as hot air
ducts, or leave it in a car parked in
direct sunlight as the temperature
may rise considerably inside the car.
• After playing, store the disc in its case.
On cleaning
• Before playing, clean the disc with a
cleaning cloth.
Wipe the disc from the center out.
• Do not use solvents such as benzine,
thinner, commercially available
cleaners, or anti-static spray intended
for vinyl LPs.
This system can only play a standard
circular disc. Using neither standard nor
circular discs (e.g., card, heart, or star
shape) may cause a malfunction.
Do not use a disc that has a
commercially available accessory
attached, such as a label or ring.
Troubleshooting
If you experience any of the following
difficulties while using the system, use
this troubleshooting guide to help
remedy the problem before requesting
repairs. Should any problem persist,
consult your nearest Sony dealer.
In the event of a problem with the
wireless sound function, have a Sony
dealer check the entire system (main
unit and surround amplifier).
The power does not turn on.
t Check that the AC power cord
(mains lead) is connected securely.
The remote control does not function.
t The distance between the remote
control and the main unit is too far.
t The batteries in the remote control
are weak.
The disc lid does not open and you
cannot remove the disc even after you
press Z.
t Try the following:
1 Press and hold N and Z on the
main unit for more than
5 seconds to open the disc lid.
2 Remove the disc.
3 Disconnect the AC power cord
(mains lead) from the wall outlet
(mains), then reconnect after
several minutes.
The system does not work normally.
t Disconnect the AC power cord
(mains lead) from the wall outlet
(mains), then reconnect after
several minutes.
General