Sony VGN-T360P - Manual (Page 40)

GSM Device Connection Errors
When attempting to connect to either an EDGE or GPRS network, the following errors may be reported if the connection cannot be made.
CCM Error Code 631
This error is typically seen if you disconnect or cancel the EDGE/GPRS connection prior to authentication. This is a user initiated error.
Resolution
Click on the Cancel button and wait for the CCM to display “Ready to Connect”. Then try again.
CCM Error Code 679
This error is typically reported if the CCM has lost a carrier signal from the EDGE or GPRS network.
Resolution
Click on the Cancel button and wait for the CCM to display “Ready to Connect”. Then try again.
CCM Error Code 691
This error is typically reported if the CCM has received an Authentication Error from the EDGE/GPRS network.
Resolution
Click on the Cancel button and wait for the CCM to display “Ready to Connect”. Then try again.
CCM Error Code 630
This error is typically reported if the CCM has detected a hardware error in the GSM Device.
Resolution
Click on the Cancel button and wait for the CCM to display “Ready to Connect”. If this error continues to be displayed turn your computer
off then on.
CCM Error Code 718, 734 or 736
These errors are typically reported if a network connection cannot be established. This may be due to poor signal strength.
Resolution
Click on the Cancel button and wait for the CCM to display “Ready to Connect”. Then try again.
CCM Error Code 635 or 744
These errors are typically reported if an unexpected error has occurred while connected to an EDGE or GPRS network. Page 40