Sony MVC-FD100 - Manual (Page 34)

34
3 If there is a device indicated with a question mark, delete it.
1 Click “ Sony DSC” or “ Sony Handycam”.
2 Click “Remove.” The “Confirm Device Removal” screen appears.
3 Click the “OK” button.
4 Turn off your camera and disconnect the dedicated USB cable from
the camera and computer.
5 Install the USB driver provided on the supplied CD-ROM.
See “Step 1 Installing the USB driver to the computer (page 29).”
Viewing images on Macintosh
OS: Mac OS 8.5.1/8.6/9.0/9.1/9.2, Mac OS X(v10.0/v10.1)
The above OS must be installed at the factory.
However, note that the upgrade to Mac OS 9.0/9.1 should be used for the
following models.
— iMac with the Mac OS 8.6 factory pre-installed and a slot loading type
CD-ROM drive
— iBook or Power Mac G4 with the Mac OS 8.6 factory pre-installed
Mac OS X(v10.0/v10.1) users can use a USB connection only when a
“Memory Stick” is used.
Display: Resolution of 800 × 600 dots or higher, 32 000-color mode or higher
The USB connector must be provided as standard.
QuickTime 3.0 or newer must be installed to play back moving pictures.
Notes
•
If you connect two or more devices that use USB to a single computer or use a hub, operation is
not guaranteed.
• Some USB devices may not operate if they are connected to the computer at the same time as
your camera.
• Operations are not guaranteed for all the recommended computer environments mentioned
above.
Step 1 Installing the USB driver to the computer (page 35)
Perform this step only when you view the images on your computer for
the first time.
Step 2 Connecting your camera to your computer using the USB cable
(page 36)
Step 3 Viewing images on Macintosh (page 36)
Recommended Computer environment
General procedure for viewing images