Sony HT-1800DP - Manual (Page 45)

Additional Information
45
US
HT-1800DP 4-244-184-11(2) US
AM tuner section
Tuning range
Models of area code U, CA
With 10-kHz tuning scale: 530 – 1710 kHz
4)
With 9-kHz tuning scale: 531 – 1710 kHz 4)
Antenna Loop antenna
Intermediate Frequency
450 kHz
Usable sensitivity 50 dB/m (at 1,000 kHz or
999 kHz)
S/N 54 dB (at 50 mV/m)
Harmonic distortion 0.5 % (50 mV/m, 400 Hz)
Selectivity
At 9 kHz:
35 dB
At 10 kHz: 40 dB
4) You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off
the receiver. Hold down PRESET TUNING + and
press ?/1. All preset stations will be erased when
you change the tuning scale. To reset the scale to
10 kHz (or 9 kHz), repeat the procedure.
Video section
Inputs
Video:
1 Vp-p, 75 ohms
Outputs
Video:
1 Vp-p, 75 ohms
General
Power requirements
Area code Power requirements
U, CA 120 V AC, 60 Hz
Power consumption
Area code Power consumption
U 185 W
CA 270 VA
Power consumption (during standby mode)
0.3 W
Dimensions 16 7/8
Ч 5 6/8 Ч 11 6/8
inches including
projecting parts and
controls
Mass (Approx.) 15 lb 14 oz
continued
Speaker section
SS-MSP75 for front and surround speakers
SS-CNP75 for center speaker
Speaker system
Full range, magnetically
shielded
Speaker units 70 mm
× 100 mm cone
type
Enclosure type Bass reflex
Rated Impedance 8 ohms
Power handling capacity (Maximum input
power)
100 W
Sensitivity level 86 dB (1 W, 1 m)
Frequency range 160 Hz – 20,000 Hz
Dimensions (w/h/d)
SS-MSP75
Approx. 3 5/8 Ч 6 Ч 5
inches
SS-CNP75 Approx. 9 1/8
Ч 3 5/8 Ч 5
inches
Mass
SS-MSP75
1 lb 13 oz
SS-CNP75 2 lb 4 oz
SA-WMSP85 for sub woofer
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6 ohm loads, from 28 – 200 Hz;
rated 100 watts, minimum RMS power, with no
more than 0.8% total harmonic distortion from
250 milliwatts to rated output (Models of area
code U only).
Speaker system Active subwoofer,
magnetically shielded
Speaker unit Woofer: 20 cm cone type
Enclosure type Acoustically loaded bass
reflex