Sony HT-C800DP - Manual (Page 19)

Getting Star
ted
HT-C800DP 4-247-292-11(1)
19 GB
Step 1: Speaker System Hookup
Before connecting the speakers, attach the color labels onto the rear panel of the speakers so
that you can identify the speakers to be connected. For details on the color, refer to “Jacks for
connecting the speakers” on page 20.
Connect the supplied speaker system using the supplied speaker cords by matching the colours
of the terminals to those of the cords. Do not connect any speakers other than those supplied
with this system.
To obtain the best possible surround sound, specify the speaker parameters (distance, level, etc.)
on page 68.
Required cords
Speaker cords
The connector and the colour tube of the speaker cords are the same colour as the jacks to be
connected.
To change the speaker cord
If you want to change the speaker cord, you can detach the supplied speaker cord from the
connector.
1 Press the connector onto a flat surface.
Make sure that the catcher is at the bottom.
2 Pull the speaker cord from the connector.
3 Twist the stripped ends of the speaker cord you want about 10 mm (3/8 inches)
and insert the speaker cord into the connector.
Make sure that the speaker cord is inserted according to its polarity: + to + and – to –.
Colour tube
(+)
(–)
(–)
catcher
(+)
continued