How to use – Sony SVD1121BPXB User Manual
Page 277
VAIO User Guide
Back
|
How to Use
Encrypting Your Data with the TPM (BitLocker)
<TPM security chip equipped models>
<BitLocker supported models>
You can use BitLocker included with Windows 8 Pro to encrypt the data on the built-in
storage device.
Refer to
Windows Help and Support for more information on the BitLocker settings and
To unlock the BitLocker-protected drive with a USB flash drive, follow these steps:
1. Press the ASSIST button while your VAIO computer is off.
The
VAIO Care Rescue Mode screen appears.
2. Select Start BIOS setup.
Enter a password if it has already been set.
The BIOS setup screen appears.
3. Press the or key to select the Security tab and change the Change TPM
State setting to Enable.
4. Press the or key to select Boot and change the External Device Boot
setting to
Enabled.
5. Change the boot device order to put Internal Hard Disk Drive in Boot Priority
before
External Device.
6. Press the or key to select Exit, select Exit Setup, and then press the Enter
key.
7. When the confirmation prompt appears after your VAIO computer restarts, select
Execute.
8. Refer to Windows Help and Support to enable BitLocker.
9. Save a password on the USB flash drive in the recovery password save window.
Then, follow the on-screen instructions to restart your VAIO computer. After the
computer restarts, the BitLocker encryption starts.
Note
After you update the BIOS settings using
VAIO Update, the BIOS settings are
restored to the default. In this case, you need to repeat the above steps.
It takes several hours to complete the BitLocker encryption.
Do not encrypt an external device containing the recovery password, such as a USB
flash drive, using Windows BitLocker Drive Encryption.
© 2012 Sony Corporation
277
Search