Sony MZ-M100 User Manual
Page 78
78
The recorder does not
work or works poorly.
• The rechargeable battery is not charged.
,
Charge the rechargeable battery.
• The volume is low.
,
Turn up the volume.
• No disc is inserted.
,
Insert a recorded disc.
• The HOLD function is turned on (“HOLD” appears in the display
when you press an operation button on the recorder).
,
On the recorder, disable HOLD by sliding the HOLD switch to
the opposite direction of the arrow
.
• The lid is not firmly closed.
,
Close the lid until it clicks. Then slide OPEN to open the lid.
• Moisture has condensed inside the recorder (for example, when the
recorder has been brought in from a cold place to a warm place).
,
Take the disc out and leave the recorder in a warm place for
several hours until the moisture evaporates.
• The AC power adaptor is not firmly connected.
,
Connect the AC power adaptor firmly to the DC IN 3V jack on
the recorder.
• The rechargeable battery or dry battery is weak (“LOW BATTERY”
flashes or nothing appears).
,
Charge the rechargeable battery, replace the dry battery with a
new one, or use the supplied AC power adaptor.
• The disc is damaged or does not contain proper recording or editing
data.
,
Reinsert the disc. Rerecord the disc. If the error message still
appears, replace it with another disc.
• There is a built-in malfunction in the system.
• While operating, the recorder received a mechanical shock, too
much static, abnormal power voltage caused by lightning, etc.
,
Restart the operation as follows.
1
Disconnect all the power sources and the USB cable.
2
Leave the recorder for about 30 seconds.
3
Connect the power source.
The display does not
turn on.
• You tried to operate the recorder with the remote control while “EL
Light” is set to “Auto Off” (page 58).
,
Use the buttons and controls on the recorder. When “EL Light”
is set to “Auto Off”, the display window turns off automatically
and it does not turn on even when you operate the recorder with
the remote control.
File names or folder
names displayed by the
File list function are
different from those
saved on the computer.
• File names and folder names that exceed the maximum display
length supported by the recorder are shortened.
The file names or folder
names are not correctly
displayed by the File list
function.
• The names contain characters that are not supported by the recorder.
Symptom
Cause/Remedy