Sony HCD-HDX678WF - Manual (Page 86)

86 US
3
Select the desired function on the
S-AIR receiver.
x When “PARTY” is set
The function changes in the same sequence
as you press FUNCTION +/– (page 47).
x When “SEPARATE” is set
The function changes as follows.
“MAIN UNIT” t “TUNER FM” t
“TUNER AM” t “DMPORT” t
“AUDIO” t …
To enjoy the same function as the unit,
select “MAIN UNIT.”
When “TUNER FM” or “TUNER AM” is
selected on the unit, you can only select the
same band for the tuner on the S-AIR
receiver. In this case, when you select other
than “TUNER FM” or “TUNER AM” on
the unit, you can select any band for the
tuner on the S-AIR receiver.
4
Adjust the volume on the S-AIR
receiver.
Note
• When the sound is other than 2 channel stereo, multi
channel sound is downmixed to 2 channel.
• The sound of the S-AIR receiver may be cut off by
operation of the unit.
To control the system from the
S-AIR receiver
You can control the system from the S-AIR
receiver by using the following buttons.
For details, refer to the operating instructions of
the S-AIR receiver.
You can enjoy the S-AIR receiver while the unit
is in standby mode by setting “S-AIR STBY” to
“ON.”
1
Press SYSTEM MENU.
2
Press X/x repeatedly until “S-AIR
STBY” appears in the front panel
display, then press
or c.
3
Press X/x to select the desired setting.
• “ON”: You can enjoy the S-AIR receiver
while the unit is in standby mode or turned
on.
• “OFF”: You cannot enjoy the S-AIR
receiver while the unit is in standby mode.
The default setting differs depending on the
model.
4
Press .
The setting is made.
5
Press SYSTEM MENU.
The system menu turns off.
Note
• When you set “S-AIR STBY” to “ON,” the power
consumption during the standby mode increases.
• When you turn the system off while “S-AIR STBY”
is set to “ON,” “S-AIR” flashes (when sound
transmission between the unit and S-AIR receiver is
not established), or lights up (when sound
transmission between the unit and S-AIR receiver is
established) in the front panel display.
• If you turn the system off with the disc tray opened
while “S-AIR STBY” is set to “ON,” the disc tray
may not close automatically.
• When the wireless transceiver is not inserted in the
unit, you cannot set the “S-AIR STBY.”
• “S-AIR STBY” is set to “OFF” automatically when
the wireless transceiver is removed from the unit.
Press Operation
H, X, x,
./> Share the same operations on the
remote and unit.
S-AIR CH Change the function of the system.
Enjoying the S-AIR receiver
while the unit is in standby
mode
For the S-AIR receiver