Sony STR-SL7 - Manual (Page 24)

24
Receiving Broadcasts
Before receiving broadcasts, make sure you
have connected FM and AM antennas to the
receiver (see page 6).
Manual memory
You can enter a frequency of the station you
want directly by using the cursor buttons, and
preset the stations to the receiver.
1
Press TUNER FM/AM to select the FM
or AM band.
2
Press MEMORY/ENTER.
The receiver enters the Manual Memory
mode.
The current frequency appears and the
preset number flashes in the display.
Do steps 3 to 5 before “PUSH” and
“ENTER” flashes in the display.
3
Press +/– to tune in a station.
If “PUSH” and “ENTER” flashes before
you tune in a station, start again from step 2.
4
Press the cursor buttons ( U or u) to
select a preset number.
If “PUSH” and “ENTER” flashes before
you select the preset number, start again
from step 2.
5
Press MEMORY/ENTER.
6
Repeat steps 2 to 5 to preset another
station.
Tip
When the FM station is tuned in, you can press
TUNER to switch the MONO mode to STEREO
mode manually.
If all preset channels are memorized before
scanning all stations, scanning stops and
“MEM. FULL” appears in the display.
To cancel
Press ?/1 during any step.
tA1tA2t...tA0tB1tB2t...tB0
C0T...C2TC1T
Automatic memory
If you don’t know the frequency of the station
you want, you can let the receiver scan all
available stations in your area and preset the
stations to the receiver.
Press and hold MEMORY/ENTER, then
press ?/1.
“AUTO MEMORY START” appears in the
display.
The receiver scans from low to high
frequencies of FM stations, then repeat
scanning of AM stations.
When a station is tuned in, the station is
automatically stored in the memory in the
following order.