Sony STR-DE435 - Manual (Page 23)

23
Other Operations
Adjustments Using the SET UP
Button
The SET UP button allows you to make the following
adjustments.
Adjusting the Control A1 II auto function
Turning on the Control A1 II auto function parameter
lets you to turn Sony components connected via
Control A1 II cords (see page 6) on automatically when
you press the corresponding function button.
Auto function is set to ON by default.
1 Press SET UP.
2
Press MENU </> to select “AUTO FUNCTION”.
3
Press +/– to select “A-FUNC ON” or “A-FUNC
OFF”.
Setting up the 2 way remote
This receiver is shipped from the factory with the 2
way remote control system set to “ON”. Normally, you
can use the receiver as is.
However, if you want to use this receiver together with
another component that is also compatible with the 2
way remote control system, be sure to perform the
following operation to limit response to signals sent
from the remote controls.
To use with the TA-E9000ES
Perform the following steps to turn OFF this unit’s 2
way remote control system. Also, be sure the TA-
E9000ES is turned on when using this unit.
To use with other components that have the
logo
Turn OFF the other component’s 2 way remote control
system. For details, refer to the operating instructions
supplied with your other components.
To use with CD players CDP-CX260 or CDP-CX88ES
Turn OFF the remote control adaptor switch on the
CDP-CX260 or CDP-CX88ES. For details, refer to the
operating instructions supplied with the CDP-CX260
or CDP-CX88ES.
Also when using several 2 way remote control system
components together, be sure to place them close
together in order to enable proper remote operation.
1
Press SET UP.
2
Press MENU </> to select “2WAY SETUP”.
3 Press +/– to select “2WAY ON” or “2WAY OFF”.