AT&T 2120 - Manual (Page 18)

16
Clock Radio Operation
To set the wakeup alarm
To set the wakeup time
To set the alarm clock, press and hold
WAKE TIME
until
the display begins blinking, then follow the steps at left
to set your desired wakeup time.
While setting the wakeup time, you can press
HOUR
or
MIN
to advance by 1 digit, or hold down the buttons to
advance more quickly.
You can press the
WAKE TIME
button at any time to
check your programmed wakeup time.
To select wakeup alarm type
Press the
WAKE MODE
button to choose whether you
want to be awakened by the radio or the build-in
buzzer.
Each time you press
WAKE MODE
a different icon will
appear to indicate your choice, as shown at left. When
no icon appears the alarm is turned off, and you will not
be awakened.
1 WAKE TIME
12:00
PM
Press and hold until time blinks.
2 HOUR
6:00 AM
Press to select wakeup hour (press
and hold to advance quickly)
3 MIN
6:30 AM
Press to select wakeup minute
(press and hold to advance quickly)
4 WAKE TIME
6:30 AM
Press to set wakeup time
to displayed time.
5 WAKE MODE
12:00
PM
Press repeatedly to select wake mode
(radio, buzzer, or alarm off).
Awake to radio
Awake to buzzer
No icon = Alarm off.
NOTE: If you set the wake mode to Radio, make sure the radio is
tuned to a station with a strong signal, and the volume is set high enough to
awaken you (see page 18).
NOTE: If electrical power is lost for more than 15 minutes, the wakeup
time will change to 12:00 and you will have to reset it.
91-000040-010-000_E2120ManualMP_R0Aug0904.qxd 8/9/2004 10:06 AM Page 16