Sony DSC-M2 - Manual (Page 96)

96
Enable printer to connect
• [USB Connect] is set to [PictBridge],
however the camera is connected to a
non-PictBridge compliant device.
Check the device.
• The connection is not established.
Disconnect and connect the USB cable
again. If an error message is indicated
on the printer, refer to the operating
instructions supplied with the printer.
Connect to device
• You tried to print images before the
printer connection was established.
Connect to a PictBridge compliant
printer.
No printable image
• You tried to execute [DPOF image]
without placing a DPOF (Print order)
mark on the image(s).
• You tried to execute [All In This Folder]
while a folder that holds only movies
was selected. You cannot print movies.
Printer busy
Paper error
No paper
Ink error
Low Ink
No Ink
• Check the printer.
Printer error
• Check the printer.
• Check if the image you want to print is
corrupted.
• The data transmission to the printer may
not be completed yet. Do not disconnect
the USB cable.
Processing
• The printer is canceling the current print
job. You cannot print until it is finished.
This may take time, depending on the
printer.
Recover data
• The data in Album has been destroyed.
Recover the data by selecting [OK].
When you want to start recording
immediately, select [Cancel] to start
your operation. However, each time you
turn on the camera, the same error
massage appears until you recover the
data.
• When you start recovering the data, the
protection of images is canceled. If you
want the images to be protected, protect
the images again (page 46).
• Even when the power source is cut off
during formatting the album, the format
will be completed. The error occures
and it can be fixed, yet the data can not
be recovered.