Sony MFM-HT205 - Manual (Page 9)

9
US
Setup
Before using your display, check that the following items are
included in your carton:
• LCD display
• Remote control
• Size AAA batteries (2)
• Power cord
• HD15-HD15 video signal cable (analog RGB)
• DVI-D video signal cable (digital RGB)
• Audio cord (stereo miniplug)
• 75-ohm coaxial cable
• CD-ROM (utility software for Windows/Macintosh, Operating
Instructions, etc.)
• Warranty card
• Quick Setup Guide
Setup 1: Use the stand
x Using the supplied stand
Open the stand.
Note
The stand is folded at the factory. Be sure not to place the display
vertically with the stand as it is. Otherwise, the display may topple over.
x Using the VESA compatible stand
When using a non-supplied VESA compatible mounting arm or
stand, use the VESA compatible screws to attach.
You can use the display with or without the supplied stand.
Setup 2: Connect the cables
Remove the connector cover.
Push the hooks and draw the connector cover towards you.
screw positions of
VESA compatible
stand (100 mm)
screw positions of the
supplied stand
Bottom-side view
• Turn off the display, computer, and other equipment
before connecting them.
• If you intend to connect:
– A computer equipped with an HD15 output connector
(analog RGB)
t See “Connecting a computer using the PC 2
connectors” (page 10).
– Video equipment that has component video output
jacks
t See “Connecting video equipment using the
COMPONENT jacks” (page 11).
– Video equipment that has composite/S video output
jacks
t See “Connecting video equipment using the
VIDEO 1/2 jacks” (page 11).
– An antenna
t See “Connecting an antenna” (page 12).
Notes
• Do not touch the pins of the video signal cable connector as this
might bend the pins.
• Be sure that the cables connected to the display does not get
pinched under the stand.
connector cover