Sony STR-DH510 - Manual (Page 37)

37 GB
B
a
si
c Op
er
a
tio
ns
Using the Sleep Timer
You can set the receiver to turn off
automatically at a specified time.
1
Press AMP MENU.
2
Press V/v repeatedly to select
“SYSTEM”, then press or b.
3
Press V/v repeatedly to select
“SLEEP”, then press or b.
4
Press V/v repeatedly to select
the preset time you want, then
press .
The display changes as follows:
OFF
y 0-30-00 y 1-00-00 y
1-30-00 y 2-00-00
When sleep timer is being used, “SLEEP”
indicator lights up in the display.
Note
A count down is displayed 1 minute before the
receiver turns off.
Tip
To check the remaining time before the receiver
turns off, repeat step 1 to 3 above. The remaining
time appears on the display.
Recording
You can record from a video/audio component
using the receiver. Refer to the operating
instructions supplied with your recording
component.
1
Press one of the input buttons
to select the playback
component.
You can also use INPUT SELECTOR on
the receiver.
2
Prepare the playback
component for playing.
For example, insert the video tape you
want to copy into the VCR.
3
Prepare the recording
component.
Insert a blank video tape, etc. into the
recording component (VIDEO) for
recording.
4
Start recording on the
recording component, then
start playback on the playback
component.
Notes
• Some sources contain copy guards to prevent
recording. In this case, you may not be able to
record from the source.
• Only analog signals are output from the analog
output jack (for recording).
• HDMI sound cannot be recorded.
O
MENU
,
V/v/B/b
AMP
MENU
Recording onto a recording
media