Sony DCR-HC36 - Manual (Page 39)

39
DCR-HC36/HC46/HC96
2-659-813-11(1)
Re
co
rdi
ng/
Pl
a
yb
a
ck
E:\SONY\2659813111\01US03BAS.fm
Searching for the starting point
Make sure that the CAMERA-TAPE
lamp lights up (p. 30).
[END SEARCH] will not work once you
eject the cassette after you have recorded on
the tape.
Touch t .
The last scene of the most recent
recording is played back for about 5
seconds, and the camcorder enters the
standby mode at the point where the last
recording has finished.
• [END SEARCH] will not work correctly when
there is a blank section between recorded
sections on the tape.
• You can also select [END SEARCH] from the
menu. When the PLAY/EDIT lamp lights up,
select the [END SEARCH] short-cut in Personal
Menu (p. 44).
You can search for the start point to start
the next recording while viewing the
pictures on the screen. The sound is not
played back during the search.
1
Touch .
2
Touch and hold (to go
backward)/ (to go forward)
and release it at the point where
you want the recording to start.
You can view about 2 seconds of the scene
recorded just before you stopped the tape.
Touch t .
The last 2 seconds (approx.) of the most
recently recorded scene are played back.
Then, your camcorder is set to the
standby.
Searching for the last scene of
the most recent recording (END
SEARCH)
END SEARCH
EXECUTING
CANCEL
0:00:00 1 60min
Touch here to cancel the operation.
Searching manually
(EDIT SEARCH)
Reviewing the most recently
recorded scenes (Rec review)
0:00:00 STBY 60min
EDIT
0:00:00 STBY 60min
EDIT