Sony PFM-42B2H User Manual
Page 64
12
(GB)
Location and Function of Parts and Controls
8
H SHIFT button
Adjusts the horizontal centering. Press this button and
then adjust the horizontal centering with the SELECT
+
M/–m button qj.
9
V SHIFT button
Adjusts the vertical centering. Press this button and
then adjust the vertical centering with the SELECT
+
M/–m button qj.
0
H SIZE button
Adjusts the horizontal picture size. Press this button
and then adjust the horizontal picture size with the
SELECT +
M/–m button qj.
qa
V SIZE button
Adjusts the vertical picture size. Press this button and
then adjust the vertical picture size with the SELECT
+
M/–m button qj.
qs
STANDBY button
Press to turn the display to the standby mode.
qd
RGB/YUV button
Press to select the format matching that of the input
signal connected to the INPUT1 or INPUT2
connector. Each press toggles between RGB and
YUV.
qf
S/VIDEO button
Press to select the signal input from the COMPOSITE
IN connector or Y/C IN connector from among the
VIDEO connectors. Each press toggles between
COMPOSITE IN and Y/C IN.
qg
Number buttons
Press to enter the index number.
qh
ID MODE (ON/SET/OFF) buttons
Press the ON button to make an index number appear
on the screen. Then enter the index number of the
display you want to operate using the number buttons
qg
and press the SET button. After you finish the
operation, press the OFF button to return from the ID
mode to the normal mode.
For details about the index number, see “Operating a
Specific Display With the Remote Commander” on page
45 (GB).
qj
SELECT +
M/–m button
Press to move the cursor (B) to an item or to adjust a
value in a menu.
Be sure to
install the
negative
<
–
end first.
qk
MENU button
Press to make the menu appear. When the menu
appears on the display panel, press to return to the
previous menu level. To clear the menu, press this
button repeatedly until the menu disappears.
ql
ENTER button
Press to select the desired item in a menu.
w;
BRIGHT +/– button
Adjusts the brightness.
wa
CONTRAST +/– button
Adjusts the contrast.
Installing batteries
Insert two size AA (R6) batteries in correct polarity.
e
E
E
e
• In normal operation, batteries will last up to half a
year. If the Remote Commander does not operate
properly, the batteries might be exhausted sooner.
Replace them with new ones.
• To avoid damage from possible battery leakage,
remove the batteries if you do not plan to use the
Remote Commander for a fairly long time.
When the Remote Commander does not work
Check that the STANDBY indicator lights up and the
REMOTE MODE in the REMOTE menu is not set to
OFF. The Remote Commander operates the display
only when both of the two conditions below are met.
• The display is turned on, or it is in the standby mode.
• The REMOTE MODE in the REMOTE menu is set
to TV or to PJ.
For details about the REMOTE MODE, see “REMOTE
menu” on page 22 (GB).