Sony ICD-P620 - Manual (Page 28)

ICD-P620 GB 3-295-268-11 (2)

GB
6
Set the alarm sound.
 Press –  or  + to select the
alarm sound either from “B-PLAY”
(playing back the message after the
alarm) or “B-ONLY” (alarm only).
 Press  PLAY/ENTER.
“ALARM ON” will be displayed.
7
Press  (stop) to exit the menu
mode.
“  ” is displayed when the number of the
message with alarm setting is selected.
At the set time, the alarm will sound
for about 10 seconds and the selected
message will be played back. (If you have
selected “B-ONLY,” only the alarm will
sound.)
During playback, “ALARM” will flash in the
display window.
When the playback ends, the unit will
stop automatically at the beginning of
that message.
To listen to the same message
again
Press  PLAY/ENTER. The same
message will be played back from the
beginning.
To cancel the alarm setting
before the playback starts
Press  (stop) while the alarm sound
is heard. You can stop even when the
HOLD function is activated.
Notes
You cannot set the alarm if you have not
set the clock or there is no message in
the selected folder (the unit will not enter
the alarm setting mode when you press
DISPLAY/MENU in Step 2).
If you try to set the alarm to play back a
message at a previously set time on another
message, “PRE SET” will be displayed,
preventing new settings.
If the alarm time comes while another
message is being played back with an alarm,
the playback stops and the new message
will be played back.
If the alarm time comes during recording,
alarm will sound for 10 seconds after the
recording is finished and playback begins.
“  ” will flash when the alarm time comes.




