Sony VGX-XL1 - Manual (Page 70)

VGX-XL1 Digital Living System 67
5 Install the hard disk upgrade in the hard disk drive bay. Secure the hard disk
upgrade in the hard disk drive bay with the screws. Install in the lower bay
when there is an open space in the lower bay.
6 Connect the cables to both of the hard disks, the one installed at the time of
purchasing and the upgraded hard disk.
Always install the serial ATA power cable and the serial ATA cable. In the
meantime, connect the serial ATA cable between the PORT (Serial ATA)
connector on the circuit board inside this device and the hard disk according
to the following list:
Below is the install location of the hard disk and the corresponding PORT
(Serial ATA) connector
Main Unit Expansion Connector
Designation
Hard Disk to Connect
PORT 0 (Port 0) Hard disk in the lower drive bay
PORT 1 (Port 1) Hard disk in the middle drive bay
PORT 2 (Port 2) Hard disk in the upper drive bay
Chp3.fm Page 67 Thursday, November 10, 2005 11:53 AM