Axis Communications 206 - Manual (Page 11)

10 AXIS 206 - Mounting
Mounting
1. If required, use the 3 supplied screws to fix the base plate to
a flat surface.
2. To use the shorter stand, e.g. for wall mounting, unscrew
the lock ring to release the camera, and remove the
extension section.
3. Re-attach the camera, adjust the angle and gently tighten
the lock ring.
Important!
Install the AXIS 206/206M
Follow the steps below to install the AXIS 206/206M on your local network (LAN). To
install the AXIS 206W, please see page 15.
1. Using the self-adhesive strip, attach the supplied cable clip to the rear panel.
2. Position and mount the camera as required - see above.
3. Connect the power adapter to the camera.
4. Fasten the power cable in the cable clip. This helps prevent accidental cable
disconnection.
5. Connect the AXIS 206/206M to the network using a standard RJ-45 network cable.
6. Select a method for setting the IP address - see the following page.
The AXIS 206 (all models) is designed for indoor use only, and must always be positioned where it is
not exposed to direct sunlight or strong halogen light, which can cause permanent damage to the
camera’s image sensor. Damage as a result of exposure to strong light is not covered by the Axis
warranty.
Lock ring
Wall mounting