Sony DR-GA500 - Manual (Page 16)

16 GB Operation
Listening to Sounds
1
Turn on the connected computer.
2
Press the  /  (on / standby) switch to turn the processor on.
The power indicator of the processor lights white.
If you connect the USB port on the computer to the USB port of the processor by the
supplied USB cable, USB drivers will be installed automatically when the processor is
turned on at the first time after connecting and starting the computer.
3
Put on the headset.
(See page 12)
4
Start playback from the computer.
To adjust the volume
Adjust the volume level of the headset, and set the microphone muting mode.
VOL (volume)
Adjust the volume level of
the headset.
MIC MUTING
ON: The microphone is set to
the MIC MUTING ON mode.
OFF: The microphone is set to
the MIC MUTING OFF mode.
Notes
 When watching films, be careful not to increase the volume too high in quiet scenes. You may hurt your
ears when a loud scene is played.
 The headset volume and the output level of the computer are not synchronised. Also note that the
microphone muting mode is not synchronised.
 The music/sound might not be output from the headset if you connect to the processor by the USB cable
and slide the INPUT switch to “USB” while using music software. In this case, restart the music software.
 Operation