Sony DCR-HC21 - Manual (Page 74)

74
DCR-HC21 2-584-905-11(1)
Warning indicators and messages
Self-diagnosis display/Warning
indicators
If indicators appear on the LCD screen or
in the viewfinder, check the following.
Some symptoms you can fix by yourself.
If the problem persists even after you have
tried a couple of times, contact your Sony
dealer or local authorized Sony service
facility.
C:(or E:) : (Self-diagnosis
display)
C:04: 
• The battery pack is not an
“InfoLITHIUM” battery pack. Use an
“InfoLITHIUM” battery pack (p. 79).
C:21: 
• Moisture condensation has occurred.
Remove the cassette and leave your
camcorder for at least 1 hour, then re-
insert the cassette (p. 82).
C:22: 
• Clean the head using a cleaning
cassette (optional) (p. 82).
C:31:  / C:32:
• Symptoms that are not described above
have occurred. Remove and insert the
cassette, then operate your camcorder
again. Do not perform this procedure if
moisture starts to condense (p. 82).
• Remove the power source. Reconnect
it again and operate your camcorder
again.
• Change the cassette. Press RESET (p.
23), and operate your camcorder again.
E:61:  / E:62:
• Contact your Sony dealer or local
authorized Sony service facility. Inform
them of the 5-digit code, which starts
from “E.”
(Battery level warning)
• The battery pack is nearly used up.
• Depending on the operating,
environment, or battery conditions,
 may flash, even if there are
approximately 5 to 10 minutes
remaining.
(Moisture condensation warning)*
• Eject the cassette, remove the power
source, and then leave it for about 1
hour with the cassette lid open (p. 82).
(Warning indicators pertaining to
the tape)
Slow flashing:
• There is less than 5 minutes remaining
on the tape.
• No cassette is inserted. *
• The write-protect tab on the cassette is
set to lock (p. 78). *
Fast flashing:
• The tape has run out. *
(Eject cassette warning)*
Slow flashing:
• The write-protect tab on the cassette is
set to lock (p. 78).
Fast flashing:
• Moisture condensation has occurred (p.
82).
• The self-diagnosis display code is
displayed (p. 74).
(Warning indicator pertaining to the
external flash)
Slow flashing:
• Still charging
Fast flashing:
• The self-diagnosis display code is
displayed (p. 74). *
• There is something wrong with the
flash.