Sony DCR-HC21 - Manual (Page 84)

84
DCR-HC21 2-584-905-11(1)
be affected as long as you are not recording
the date.

Procedures
Connect your camcorder to a wall outlet
using the supplied AC Adaptor, and leave it
with the POWER switch set to OFF (CHG)
for more than 24 hours.
To change the battery of the Remote
Commander
 While pressing on the tab, inset your
fingernail into the slit to pull out the
battery case.
 Place a new battery with the + side facing
up.
 Insert the battery case back into the
Remote Commander until it clicks.
Tab
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
Caution
Danger of explosion if battery is
incorrectly replaced. Replace only with
the same or equivalent type recommended
by the manufacturer.
Discard used batteries according to the
manufacturer’s instructions.
• A button-type lithium battery (CR2025) is used
in the Remote Commander. Do not use batteries
other than the CR2025.
• When the lithium battery becomes weak, the
operating distance of the Remote Commander
may shorten, or the Remote Commander may
not function properly. In this case, replace the
battery with a Sony CR2025 lithium battery.
Use of another battery may present a risk of fire
or explosion.
Using the Strap Belt
as a wrist strap
This is useful for carrying your camcorder.
1
Open the hook and loop fastener
of the hand pad (
) and remove
it from the ring ( ).
Hand pad
2
Move the hand pad fully to the
right (
), then close the hook
and loop fastener again ( ).
2
1
3
Use the Strap Belt as a wrist
strap as illustrated.