Anritsu ML2430A - Manual (Page 194)

FA Auto average
Syntax: FA
Remarks: Automatic Filter on. Allows the system to automatically select the filter
used to reduce the jitter in the display.
Related
Commands: FM, FH
FH average hold
Syntax: FH
Remarks: Hold filter sets the filter mode to Manual from Auto, but retains the auto fil-
ter setting. This function is the same as the AVGM command.
Related
Commands: FM, FH, FA
FM Set average value
Syntax: FM<val>EN
val: 1 to 512
Remarks: Sets the filter length for the averaging of sensor data. For HP 437B emula-
tion, the command accepts 1 to 512 in 2-to-the-power steps. For example,
1, 2, 4, 8, 16,...256, 512.
Related
Commands: FH, FA
FR Frequency of the input signal
Syntax: FR<val><units>
val:
units: GZ (GHz)
MZ (MHz)
KZ (KHz)
HZ (Hz)
EN (Hz)
Remarks: Sets the frequency of the input signal so that the correct cal factor is used.
ML2430A OM 6-107
GPIB OPERATION HP 437B EMULATION COMMANDS