Sony DCR-PC350 - Manual (Page 100)

Dubbing/Editing 100
When connecting with an i.LINK
cable
Touch [i.LINK], then . Go on to “Step
2 : Adjusting the synchronization of the
VCR” (p. 102).
To set the [IR SETUP] code
When you connect with an A/V connecting
cable, you need to check the [IR SETUP] code
signal to see if your VCR can be operated by
your camcorder (infrared ray emitter).
1 Touch , then [IR SETUP].
2 Select the [IR SETUP] code of your VCR
with
/ , then touch .
For the [IR SETUP] code of your VCR,
refer to “[IR SETUP] code list” (p. 101).
When there is more than one code listed for
the manufacturer of your VCR, try each
code and find the most appropriate one.
3 Touch [PAUSEMODE].
4 Select the mode to cancel recording
pause on your VCR, then touch
.
Refer to the operating instructions supplied
with your VCR for details on operation.
5 Point the infrared ray emitter of your
camcorder towards the remote sensor on
your VCR, from about 30 cm (12 in.)
away, with no obstructions.
6 Insert a cassette into your VCR, and set
the VCR to recording pause.
7
Touch [IR TEST].
8 Touch [EXEC].
The recording starts on your VCR when the
setting is correct. [Completed.] appears
when the [IR SETUP] code test is finished.
Go on to “Step 2 : Adjusting the
synchronization of the VCR” (p. 102).
When recording fails to start, select another
[IR SETUP] code and try again.
Infrared ray emitter
VCR
Remote sensor