Sony KE-42M1 - Manual (Page 28)

28
Connecting a DVD Player with S Video and Audio
Connectors
Use this hookup if:
• Your DVD player does not have component (Y, P
B
, P
R
) jacks.
Tip
If your DVD player has component video output connectors, for best picture quality, use the
connection described on page 27.
The Y, P
B
and P
R
jacks on your DVD player are sometimes labeled as Y, C
B
and C
R
, or Y, B-Y
and R-Y. If so, connect the cables to the matching colors.
Disconnect all power sources before making any connections.
1
Using an AUDIO cable, connect the DVD player’s AUDIO OUT jacks to
the TV’s AUDIO IN jacks.
2
Using an S VIDEO cable, connect the DVD player’s S VIDEO OUT jack
to the TV’s S VIDEO IN jack (VIDEO IN 1 or 3).
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
sure “Auto YC” in the
(Setup) menu is set to “On” to view the S VIDEO input (see page
23).
Tips
• You can also use the VIDEO IN 2 jacks located on the front of the TV to connect your
DVD player.
• To take advantage of the Wide Screen Modes, set the aspect ratio of the output signal to
16:9 on your DVD player. For details, refer to the operating instructions supplied with your
DVD player.
• Use VIDEO 1/2/3 on the remote control to switch to the DVD player input.
• If your DVD player is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of
the S VIDEO cable.
HD/DVD IN
AUDIO OUT
(VAR/FIX)
P R
P B
Y
CENTER SPEAKER
IN
180W (6 ) MAX
VIDEO IN
1
S VIDEO
VIDEO
AUDIO
L(MONO)
R
AUDIO
L
R
AUDIO
L(MONO)
R
3 4
S VIDEO cable
(not supplied)
DVD player
AUDIO cable
(not supplied)
Rear of TV
S VIDEO
AUDIO-R
(red)
AUDIO-L
(white)
VIDEO
(yellow)