Sony STR-DA3500ES - Manual (Page 68)

68 US
D:\NORM'S JOB\SONY HA\SO0046\STR-DA3500ES\U VERSION\US\4144907111\01US-
STRDA3500ESUC\070SET.fm masterpage: Left
STR-DA3500ES
4-144-907-11(1)
5
Press V/v repeatedly to select
the speaker pattern you want.
1
Press GUI MODE repeatedly to
select “GUI ON”.
The GUI menu appears on the TV screen.
Press MENU if the GUI menu does not
appear on the TV screen.
2
Press V/v repeatedly to select
“Settings”, then press or b.
The Settings menu list appears on the TV
screen.
3
Press V/v repeatedly to select
“Speaker”, then press or b.
4
Press V/v repeatedly to select
“Test Tone”, then press .
5
Press B/b repeatedly to select
test tone type, then press .
6
Press V/v repeatedly to select
the speaker you want to adjust,
then press
.
The test tone is output from each speaker
in sequence.
7
Press V/v repeatedly to adjust
the parameter, then press .
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–.
• The adjusted value is shown on the display
during adjustment.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely. Check to see if they are connected
securely and cannot be disconnected by
pulling on them slightly.
• The speaker cords may have the short-circuit
problem.
When a test tone is output from
a different speaker than the
speaker displayed on the
screen
The speaker pattern to the connected speaker
is not set up correctly. Make sure the speaker
connection and the speaker pattern match.
Making settings with the Test
Tone menu
MENU
,
V/v/B/b
GUI
MODE