Sony HDR-CX500V - Manual (Page 98)


Table of C
on
ten
ts
U
seful R
ec
or
ding
Techniques
Inde
x
Set the GPS switch to ON in advance.
Steps
(MENU)
 
[CLOCK/ LANG] (under [GENERAL SET] category)

[AUTO CLOCK ADJ]

a desired setting
  
 ON Adjusts the clock automatically.
OFF Does not adjust the clock automatically.
Notes
You must set the date and time on your camcorder before using your camcorder (p. 22).
There may be discrepancies of a few seconds even if [AUTO CLOCK ADJ] is activated.
The clock is adjusted automatically by [AUTO CLOCK ADJ] when you turn off your camcorder if the
camcorder is receiving a GPS signal while it is being used. The clock is not adjusted until the camcorder
is turned off. Also, the clock is not adjusted unless the camcorder is receiving a GPS signal, even if the
GPS switch is set to ON.
 AUTO AREA ADJ (Auto area adjustment) (HDR-CX500V/CX520V)
Your camcorder will compensate for a time differences with the current area automatically
when it detects a time difference, by acquiring the current location information from GPS.
Set the GPS switch to ON in advance.
Steps
(MENU)
 
[CLOCK/ LANG] (under [GENERAL SET] category)

[AUTO AREA ADJ]

a desired setting
  
 ON Compensates for the time difference with the current area automatically.
OFF
Does not compensate for the time difference with the current area
automatically.
Notes
You must set date and time on your camcorder before using your camcorder (p. 22).
 DST SET/SUMMERTIME
You can change this setting without stopping the clock. Set to [ON] to move the time forward
1 hour.
Steps
(MENU)
 
[CLOCK/ LANG] (under [GENERAL SET] category)

[DST SET] or [SUMMERTIME]

a desired setting
  
 OFF Does not set the DST SET.
ON Sets the DST SET.
 LANGUAGE SET
You can select the language to be used on the LCD screen.





