Sony KDE-55XBR950 - Manual (Page 25)

23
Setup
Installing the TV
1
Connect the display interface cable (supplied) to the DISPLAY SIGNAL IN
jack, and the AC power cord (supplied) to the AC IN jack of the unit.
Disconnect all power sources before making any connections.
BLACK WHITE
DISPLAY SIGNAL IN
SONY EXCLUSIVE CABLE ONLY AC IN
WHITE
DISPLAY SIGNAL IN
SONY EXCLUSIVE CABLE ONLY AC IN
BLACK
Display interface
cable (supplied) Tighten the
screw slowly
until the screw
is stabilized.
AC power cord
(supplied)
Display
interface
cable
(supplied)
AC power cord
(supplied)
Tighten the
screw slowly
until the screw
is stabilized.
KDE42XBR950
KDE50XBR950
KDE61XBR950 KDE55XBR950
Do not tighten the screws too much. It may damage the
screws.
Insert the connector until you hear a click. (Both sides of the
connector should be held securely by the clips.)
After connecting, make sure the connectors are firmly plugged
in and can not easily be pulled out.
Refer to the optional accessory’s instruction manual for proper
cable installation.
PDM-5510 is only compatible with MBD55XBR950 for the best
picture quality. When setting up the TV, please clarify the
correct combination of the display unit and the media receiver
unit.
(Continued)